Main Site Nav
Topics Topics Edit Profile Profile Help/Instructions Help    
Search Last 1|3|7 Days Search Search Tree View Tree View  

Speed jumper settings on front of cha...

Trish's Escape from Hardware Hell Help Board » Setup and Configuration » Drivers, Jumper Settings & Manuals » Speed jumper settings on front of chassis. « Previous Next »

Author Message
Kenneth Barber
Posted on Tuesday, May 16, 2000 - 7:23 pm:   

I have a generic chassis and need to set the speed settings on the front panel. There are three rows of jumpers on the back. I know it does not need the numbers to run but it looks better.
Danny Albers
Posted on Wednesday, May 17, 2000 - 6:02 am:   

If you dont have the map you can do what I used to.

Take the front panel off so you can access the jumpers, turn on the computer and pause it at the first screen. With all the jumpers off, start putting them on one by one, checking the front after each on to see the effect. This will not harm your case, even if you put one on wrong. Make sure you are insulated or using insulated pliers. Its a simple matter of trial and error and patience. This always worked for me whenever I did not get a jumper map with a case.

Add Your Message Here
Post:
Username: Posting Information:
This is a public posting area. Enter your username and password if you have an account. Otherwise, enter your full name as your username and leave the password blank. Your e-mail address is optional.
Password:
E-mail:
Options: Enable HTML code in message
Automatically activate URLs in message
Action:

Administration Administration Log Out Log Out   Previous Page Previous Page Next Page Next Page