| Author |
Message |
Reed Pascal Tarpley
| | Posted on Sunday, September 26, 1999 - 3:25 pm: | |
Yet another Elpina disaster,
I have an Elpina V1.2 MB w/ 4PCI&3ISA slots, 4SIMM72pin memory slots, and a Socket 7 Cyrix 133MHZ CPU
I am trying to install a Pentium 166MHZ Socket 7 chip and need the jumper changes required to the MB
I have checked Amptron, pcchip, Ability, and Elpina web sites for this MB without success.
Does anyone know where I can find the jumper settings for this type of MB?
It is the oldest Elpina I have encountered. |
Paul Wigley
| | Posted on Sunday, September 26, 1999 - 3:25 pm: | |
I have an Elpina board which says V1.2 but mine is a twin pentium II board with agp but I don't know the settings for that either. |
john maccan
| | Posted on Monday, September 23, 2002 - 7:27 pm: | |
I really need help with this Elpina board
I can't find out anything on the board, in english anyway. My nephew bought the board for my daughter
with a PII 350 CPU Athalon.
I can't figure out where the power wire goes, led's, internal speaker, etc.. |
Cecil
| | Posted on Monday, September 23, 2002 - 9:15 pm: | |
Will be willing to help, but need more info on the motherboard. |
Cecil
| | Posted on Tuesday, September 24, 2002 - 3:15 pm: | |
Well.... I did some checking on the motherboard. What I read wasn't good. From what I gathered it's one of the worst motherboards made and has very little or no support. All the suggestions I've read are to dump it and get a different brand of motherboard. |
|
