Main Site Nav
Topics Topics Edit Profile Profile Help/Instructions Help    
Search Last 1|3|7 Days Search Search Tree View Tree View  

Can't boot into WinXP after installin...

Trish's Escape from Hardware Hell Help Board » Setup and Configuration » All the Rest » Can't boot into WinXP after installing new ECS K7SEM Motherboard with 900Mhz Duron « Previous Next »

Author Message
Bob Johnson
Posted on Thursday, May 2, 2002 - 11:20 pm:   

My Computer consists of a new ECS K7SEM Mainboard with 900Mhz Duron, 256meg, Seagate 30gig HD and 10*DVD. Windows XP is loaded on the Seagate, this harddrive is off my old board.
The system will post and then starts to boot into windows and it goes to a blue error screen with this message.

A problem has been detected and windows has been shut down to prevent damage to your computer.
It also says I could have a virus or HD is not connected right or not configured correctly.
Also gives this

Technical information:
*** STOP: 0x0000007b (0xf993f640,0xC0000034,0x00000000,0x00000000)
I have tried reseating memory, different cables, different memeory(pc133 128mb) and it comes back to the same error.
I tried the Harddrive from the computer I am using right now and get the same error.
Something not set right in the BIOS?
If anyone has any ideas, it would be greatly appreciated. Thanks for your help.
Posted on Friday, May 3, 2002 - 7:45 am:   

Sounds like the hard drive was running on your old mainboard and the operating system configured for such.

If that is the case then a clean install of the operating system might be best. Of course after an fdisk and format.
Posted on Friday, October 18, 2002 - 10:05 am:   

For getting help please look into the Microsoft Knowledge Base Article - Q314082.
May be it helps.
Regards, Schelle (Germany)

Add Your Message Here
Username: Posting Information:
This is a public posting area. Enter your username and password if you have an account. Otherwise, enter your full name as your username and leave the password blank. Your e-mail address is optional.
Options: Enable HTML code in message
Automatically activate URLs in message

Administration Administration Log Out Log Out   Previous Page Previous Page Next Page Next Page