| Author |
Message |
Mark Warner
| | Posted on Friday, December 31, 2004 - 9:46 pm: | |
I decided to upgrade my Motherboard to a Abit NF7-S2G. When I try to boot the system after the new mobo is installed the system starts to boot but there is no video signal. I have disconnected and reconnected everything twice with the same results. Not sure if it is a bad board or maybe the power supply. Here is my configuaration
AMD XP 2200+
512 DDR266 PC2100
ATI 9600XT
Turtle Beach Sound Card
Linsys Wireless-G
When I put my old board back, a Mainbaord K7VTA3, everything works fine.
|
Mark Warner
| | Posted on Saturday, January 1, 2005 - 9:59 pm: | |
Problem Solved, the CMOS jumpers are referred to incorrectly in the manual, the CMOS was allways being cleared so it would not post. |
Chris
| | Posted on Saturday, February 5, 2005 - 2:05 pm: | |
I upgrade my Motherboard to a Abit NF7-S2G. I have ab AMD xp 2600 and I cannot get the bios upgraded therfor I can't install windows xp. The bios flashes and then it changes back |
|
